Home > Klassic Keyless Vehicle Entry >

Klassic Keyless GM B-Body 2 Door (1965-1970) Keyless Entry System with Trunk Release

Klassic Keyless GM B-Body 2 Door (1965-1970) Keyless Entry System with Trunk Release
 
Alternate Photos:


List Price: $399.95
Price: $394.95
Savings: $5.00



Availability: Usually Ships in 24 to 48 Hours
Part Number: KK-27-01203-23
Qty:

Description
 
1965-70 General Motors B-Body 2 Door Keyless Entry Kit with Trunk Release

Buick:
Wildcat, Electra 225, Le Sabre
Chevrolet: Bel Air, Biscayne, Caprice, Impala
Oldsmobile: 98, Delmont 88, Delta 88, Dynamic 88, JetStar, Starfire
Pontiac: Bonneville, Catalina, 2+2, Executive, Grand Prix, Star Chief
1965 1966 1967 1968 1969 1970


Keyless Entry for your classic car

Klassic Keyless has engineered a system that will retro-fit your classic bringing full modern day convenience of remote door locking & unlocking to your classic car. Full color, step-by-step instruction manual will walk you through the installation process.


Remote Vehicle Entry System Includes:

Keyless entry module with on-board relays for a clean installation
(2) Three button remote controls
(2) Door lock actuators with 15 lbs. of pulling force & built-in overload protection
(2) Actuator mounting brackets
(2) Rubber door jamb boots
(2) Actuator connecting rods and clips, wire harness, full color step by step instruction manual, and all necessary hardware.


Power Trunk Release INCLUDED

This system is full vehicle keyless entry system: In addition to the parts listed above, you will also receive: 1 Power trunk latch, wire and wire loom, full color step by step instruction manual, trimming template, and all necessary hardware. Our Power Trunk Latch option allows you to be able to open the trunk by using the keyless entry remote but also retains the factory lock cylinder and key operation. This kit comes with everything needed to replace your factory manual trunk latch with our upgraded power latch and hook it up to your new keyless entry system. Please note that some vehicles do require the installer to trim some metal to enlarge the opening for the new power latch. This trimming does not affect the mounting of the original latch should you decide to reinstall it in the future. In addition to the tools shown above, you may need a die grinder and metal burr to enlarge the hole for installation.

Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

Klassic Keyless Vehicle Entry